Mutec MC-4 Service Manual download pdf (Page 10)

\\\\\\\\\\\\\

C O N T R O L E L E M E N T S

> > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > > >

Manual SDs-01 E 3.2.2003 18:26 Uhr Seite 6

1 HD VIDEO OUT

This pair of outputs transfers HD tri-level video sync reference clock signals.

The individual BNC connectors of the output pair are marked as A and B; this

allows, for example, for a simple documentation of the connected devices.

For adjusting these outputs see chapter OPERATION.

2 SD VIDEO OUT

This pair of outputs transfers SD video sync reference clock signals. The

individual BNC connectors of the output pair are marked as A and B; this

allows, for example, for a simple documentation of the connected devices.

For adjusting these outputs see chapter OPERATION.

3 WC LK OUT 1 – 3

These 3 pairs of Word Clock outputs transfers either all standard Word

Clock rates as well as Word Clock x 256 for older digidesign ProTools™ sys-

tems. Their numbering is aligned to the corresponding functional menus on

the front panel. The individual BNC connectors of an output pair are marked

as A and B; this allows, for example, for a simple documentation of the con-

nected devices. For adjusting these outputs see chapter OPERATION.

4 AES/EBU OUT 5

These 2 AES/EBU outputs transmit a transformer-balanced electrical

blank-frame clock signal. Their numbering is aligned to the corresponding

functional menu on the front panel. The individual XLR connectors of this

output pair are marked as A and B; this allows, for example, for a simple

documentation of the connected devices.

For adjusting these outputs see

chapter OPERATION.

5 S/PDIF OUT 6

This 2 S/PDIF outputs, available as optical and coaxial interfaces, transmit an

optical S/PDIF blank frame signal and an unbalanced electrical S/PDIF blank

frame signal. Their numbering is aligned to the corresponding functional

menu on the front panel. For adjusting these outputs see chapter OPERA-

TION.

6 MAINS IN, Power Switch + Mains connector (IEC)

This is the main switch for switching the device on and off. Connect the

supplied IEC power cable to the device‘s mains connector. Make sure that

the power switch is turned off before connecting the device to your power

source finally. Line voltages within the range of 90…260 V with a frequency

of 50 or 60 Hz can be applied. The internal power supply will automatically

make all necessary adjustments.

Heed the SAFETY INSTRUCTIONS at the beginning of this manual!

MC-3.2 SMART CLOCK HD Rear Panel

Refer to the »Generatable Word Clock Fre-

quencies« and »Generatable AES/EBU and

S/PDIF Frequencies« sections in the APPENDIX

for a full list of all Word Clock, AES/EBU and

S/PDIF clock rates that can be generated.

Refer to the »Technical Data« section in the

APPENDIX for a full list of all available SD

and HD video format and frame rate combi

nations.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comments to this Manuals

No comments

Mutec MC-4 Service Manual Page 10

Comments to this Manuals